Energy Saving Refrigerated Air Dryer Compressed Ingersoll Rand Air Dryer

Super Cooling 125HP 18m3/min Cheaper energy saving compressed air dryer

Features of High-temp Refrigerated Air Dryer:

Capacity: 18m3/min

 Working Pressure: ≤13bar
Max.inlet temp: 82°C Max Ambient Temp:50°C
Min.Ambient Temp: 5°C Refrigerant: R22, R407C,R134A,R410A
Cooling type: Air-cooled&Water-cooled Dew Point: 2°C ~8°C

Why compressed air purification?

Compressor alone is not enough.In most cases,untreated compressed air is naturally dirty,oily and wet.This condition is certainly notdesirable for industrial applications and could directly or indirectlylead to the following situations.

• Reduction in efficiency of expensive pneumatic tools & machineries

• Frequent costly maintenance of pneumatic tools & machineries

• Lost of production hours with increased machines down time

• High rejection rate of products

• Inability to meet delivery deadlines

• Unsatisfied customers

4. What should I pay attention to when using the dryer?

The following matters should be noted when using a dryer:

1 The flow pressure and temperature of the compressed air should be within the allowable range of the nameplate;

2 The installation site should be ventilated, with less dust, sufficient heat dissipation and maintenance space around the machine and can not be installed outdoors to avoid rain and direct sunlight;

3 The dryer usually allows no foundation installation, but the ground must be leveled;

4 should be as close as possible to the user point to avoid the pipeline is too long;

5 There should be no detectable corrosive gases in the surrounding environment, especially if it is not compatible with ammonia refrigeration equipment;

6 The filtration accuracy of the pre-filter of the dryer should be appropriate, and the high precision is not necessary for the dryer;

7 The cooling water inlet and outlet pipes should be set independently, especially the outlet pipe should not be shared with other water-cooling equipment to avoid the drainage caused by the pressure difference;

8 Keep the automatic drainer drained at all times;

9 Do not start the dryer continuously;

10 The actual measurement of compressed air parameters of the dryer, especially if the intake air temperature and working pressure do not match the rated value, should be corrected according to the “correction factor” provided by the sample to avoid overload operation.